Show above in dark.
ClearSonic IsoPacs are our most popular isolation packages, and can easily be modified to fit your specific needs.
IsoPacs A, B, E, F, G, and H feature the ClearSonic Lid System, that helps reduce the amount of sound that would normally escape upwards. The Lid is especially helpful if you have a room with high, hard ceilings. IsoPacs C and D are for applications where the lid is not necessary, but still feature SORBER absorption baffles to control the reflected sound. IsoPacs E through H can be used for a variety of applications including vocal and voice-over work.
ClearSonic Panels are a reflective sound barrier but do not absorb sound while SORBER is a great sound absorber but not a great barrier. Therefore, our most effective systems, such as MegaPac, use ClearSonic Panels all the way around the perimeter. Having ClearSonic Panels with Height Extenders in the back also greatly reduces the size of the open area where sound can escape. Because of this, MegaPac and similar booths will reduce sound leakage up to 70% while systems with only SORBER in the back will reduce leakage around 50%. The rear panels are usually not attached to the front panels. They simply butt together or overlap a bit. An access "door" panel is created at the overlap location
IsoPac B is similar to IsoPac A in sound reduction, but is slightly smaller, and allows for the bass drum to be seen in the front.
There are six ClearSonic panels with AX12 extenders in the front, and three S5-2 SORBER baffles in the rear. The acrylic panels are a total of 6.5' tall, and the S5-2 baffles are 5.5' tall, so there is a foot of open space around the rear of the booth allowing for air exchange.
7' wide x 8' deep x 6.5' tall
(1) A5-6 - 6-section CSP
(3) S5-2 - 4'W x 5.5'H SORBER baffle (rear)
(6) AX12 - 12" height extenders
(1) STC5 - 2'W x 5.5'D center lid section
(2) STS5 - 2'W x 5.5'D side lid section
(4) S2 - 22"W x 2'H SORBER baffle
(1) Fan - 6", 2-speed, low noise fan
Amount of Sound Reduction: