PICTURED ABOVE IN DARK GREY
IsoPacs E can be used for a variety of applications including vocal and voice-over work.
The IsoPacs are easy to get in and out of. The acrylic wraps around the front of the booth, while the SORBER panels wrap around the rear. Since SORBER panels don't actually connect to the ClearSonic Pane ls, you can simply use one side of an S5-2 (two sections hinged together) as a "door".
(1) A5-6, (6) AX-12, (3) S4-2 baffles lining the front, (2) S5-2, (1) STC5, (2) STS5, FAN
*NOTE: The Vocal IsoBooth contains (2) S5-2 SORBER panels, not (3) as pictured.*
This setup is a variation of IsoPac B and includes more SORBER product than an IsoPac B. The above system is shown with three S4-2 units which are 44 inches high where as the IsoPac B includes four S2 units which are only 24 inches high. Please note that the S4-2 SORBER units are also about 2 inches wider than two units of A5 ClearSonic Panel. This means that the outside S4-2 units will extend beyond the outside edge of the A5-6 ClearSonic Panel by a couple of inches on both sides. Twelve S2 baffles secured with Velcro could be substituted in place of the S4-2 units for a better fit (meaning more interior space) at the same price. Two levels of S2 panels would be 48 inches high where as the S4-2 is just 44 inches high. Please note that none of our booth configurations are intended to be air tight or sound proof. We recommend leaving air gaps on either side of the Lid panels and above the S5-2 back units to allow for some air exchange. A quiet 2-speed clip-on fan is included in the cost of all booth configurations that have lids to also help facilitate air exchange.