Eight
mono microphone/line inputs and four stereo line inputs. Two of the stereo
inputs also offer mono microphone input capability.
10
Low-noise, High-precision Mic Preamps
Ten
high-performance head amplifiers will deliver optimum performance with any
dynamic or condenser microphone.
Phantom
Power
All
ten mic preamps feature switchable phantom power for studio condenser
microphones. A single switch turns phantom power on or off for all 10 channels.
Insert
I/O
Add
compressors, EQ, or other signal-processing gear to the mono channels as
required via insert I/O patch points.
Four
Buses (Stereo and Group)
The
MG16/4 features a stereo group bus and outputs that can be used for convenient
channel grouping, in addition to the main stereo bus.
3-band
Channel EQ & HPF
Smooth,
"musical-response" 3-band equalizers on all input channels. All mono microphone
input channels also feature a switchable highpass filter that can be used to
cut out unwanted low-frequency noise.
Two
Aux Sends & Stereo Aux Return
Each
input channel has two auxiliary sends - one post-fader and one switchable for
pre- or post-fader operation - affording plenty of flexibility for external
signal processing and monitoring. A stereo auxiliary return is also provided.
Illuminated
Switches
Illuminated
ON (ST buss assign), PFL (Pre-Fader Listen), and phantom-power switches provide
easy visual confirmation of critical console settings.
Rack
Mount Adaptors Included
Desktop
or rackmounted, your MG mixer will happily integrate in any setup. Rack mount
adaptors are provided.
SPECS:
MG16/4
Total Harmonic Distortion
Less than
0.1 % (THD+N)
20 Hz - 20 kHz @ +14 dB 600
Ω
(ST OUT)
Frequency Response
0 +1, -3
dB
20 Hz - 20 kHz @ +4 dB 600
Ω
(ST OUT)
Input Hum & Noise*1
-128 dB 20
Hz - 20 kHz, Rs=150
Ω, Input Gain=Maximum, Input sensitivity=-60
dB
*1
Hum & Noise are measured with a 6 dB/octave filter @ 12.7 kHz;equivalent to
a 20 kHz filter with infinite dB/octave attenuation.
*2 Turn over /roll-off frequency of shelving : 3 dB below maximum variable
level.
MG16/4 INPUT CHARACTERISTICS
Connection
Gain Trim
Actual Load Impedance
For Use With Nominal
Input Level *1
Connector In Mixer
Nominal
Max. before Clip
CH IN MIC *7
-60
3 kΩ
50 - 600
Ω
Mics
-60 dB (0.775 mV)
-40 dB (7.75 mV)
XLR-3-31 type *2
-16
-16 dB (123 mV)
+4 dB (1.23 V)
CH IN LINE *7
-34
10 kΩ
600
Ω
Lines
-34 dB (15.5 mV)
-14 dB (155 mV)
Phone Jack (TRS) *3
10
+10 dB (2.45 V)
+30 dB (24.5 V)
ST CH MIC IN *8
-60
3 kΩ
50 - 600
Ω
Mics
-60 dB (0.775 mV)
-40 dB (7.75 mV)
XLR-3-31 type *2
-16
-16 dB (123 mV)
-6 dB (388 mV)
ST CH LINE IN *8
-34
10 kΩ
600
Ω
Lines
-34 dB (15.5 mV)
-14 dB (155 mV)
Phone Jack *4
10
+10 dB (2.45 V)
+30 dB (24.5 V)
ST CH INPUT *9
10 kΩ
600
Ω
Lines
-10 dB (245 mV)
+10 dB (2.45 V)
Phone Jack *4
RCA Pin Jack
CH INSERT IN *7
10 kΩ
600
Ω
Lines
0 dB (0.775 V)
+20 dB (7.75 V)
Phone Jack (TRS) *1
AUX RETURN [L, R]
10 kΩ
600
Ω
Lines
+4 dB (1.23 V)
+24 dB (12.3 V)
Phone Jack *3
2TR IN [L, R]
10 kΩ
600
Ω
Lines
-10 dBV (316 mV)
+10 dBV (3.16 V)
RCA Pin Jack
MG16/4 OUTPUT
CHARACTERISTICS
Connection
Actual Source Impedance
For Use With Nominal
Output Level *1
Connector In Mixer
Nominal
Max. before Clip
ST OUT [L, R]
150
Ω
600
Ω
Lines
+4 dB (1.23 V)
+24 dB (12.3 V)
XLR-3-32 type *2
Phone Jack (TRS) *4
GROUP OUT (1 - 2)
150
Ω
10 kΩ
Lines
+4 dB (1.23 V)
+20 dB (7.75 V)
Phone Jack (TRS) *6
CH INSERT OUT *7
150
Ω
10 kΩ
Lines
0 dB (0.775 V)
+20 dB (7.75 V)
Phone Jack (TRS) *5
REC OUT [L, R]
600
Ω
10 kΩ
Lines
-10 dBV (245 mV)
+10 dBV (2.45 V)
RCA Pin Jack
C-R OUT [L, R]
150
Ω
10 kΩ
Lines
+4 dB (1.23 V)
+20 dB (7.75 V)
Phone Jack (TRS) *6
PHONES OUT
100
Ω
40
Ω
Phones
30 mW
75 mW
Stereo Phones Jack
*1 In
these specifications, when dB represents a specific voltage,
0 dB is referenced to 0.775 Vrms. *2 XLR type connectors are balanced. *3 CH INPUT Phone Jacks (TRS) are balanced. [T: HOT, R: COLD, S:
GND] *4 Phone Jacks are unbalanced. *5 INSERT Phone Jacks (TRS) are unbalanced. [T: OUT, R: IN, S: GND] *6 Phone Jacks (TRS) are impedance balanced. [T: HOT, R: COLD, S:
GND] *7 MG12/4: CH1 - CH4, MG16/4: CH1 - CH8, MG16/6FX: CH9 (L)/10 (R),
CH11 (L)/12 (R), MG24/14FX: CH1 - 16, MG32/14FX: CH1 - 24 *8 MG12/4: CH5 (L)/6 (R), CH7 (L)/8 (R), MG16/4: CH9 (L)/10 (R),
CH11 (L)/12 (R),
MG16/6FX: CH13 (L)/14 (R), CH15 (L)/16 (R), MG24/14FX: CH17 (L)/18 (R),
CH19 (L)/20 (R), MG32/14FX: CH25 (L)/26 (R), CH27 (L)/28 (R) *9 MG12/4: CH9 (L)/10 (R), CH11 (L)/12 (R), MG16/4: CH13 (L)/14 (R),
CH15 (L)/16 (R), MG24/14FX: CH21 (L)/22 (R), CH23 (L)/24 (R),
MG32/14FX: CH29 (L)/30 (R), CH31 (L)/32 (R) *10 CH INPUT XLR type connectors and Phone Jacks (TRS) are balanced.
[T: HOT, R: COLD, S: GND] *11 TB IN XLR type connector is unbalanced. *12 MG24/14FX: CH1 - 16, MG32/14FX: CH1 - 24
Specifications and appearance subject to change without notice.
All trademarks and registered trademarks are property of their respective
owners.
Warranty Information:
Tech Support 714.522.9011 (Pro audio- 1 year parts and labor / Power amps & speakers- 3 years parts and labor / PSR keyboards- 1 year parts and 90 days on labor Pro keyboards- 1 year parts and 1 year labor Edrums- 1 year parts and 90 days on labor / Guitars / Acoustic- lifetime limited / Guitars/Electric- 1 year parts and 1 year labor) Yamaha Website PLEASE NOTE: We cannot ship Yamaha products outside the U.S. and its territories.
This item is not currently available under this SKU. Call Toll Free 1-877-778-7845 for information about this item #MG16_4KIT. You'll be glad you did! or check Live Sound|Mixers|Yamaha| for related items, or try SEARCH on MG16_4.
3900 Fiscal Ct, Suite 200 West Palm Beach, Florida 33404 USA
Telephone: 1-877-778-7845
Toll Free or 561-842-7451
Fax:
561-840-9032Contact Us! Hours: Mon-Fri 930 am - 630 pm ET/
Sat 11 am - 4 pm ET/Sun: Closed
Zoom / More pics 
Print this Page 
Gifts 
Details 
More Pics 
Warranty 
