2 stereo volume controls and 2 headphone jacks, to accommodate 2 listeners.
In rehearsals, headphones are often used to keep sound levels down to avoid disturbing neighbors. In the recording studio, headphones are most often used in the overdubbing process, where new musical tracks are recorded in synchronization with previously recorded tracks. The musicians doing the overdub hear the already recorded tracks in their headphones, and play along with them. Because of the presence of open microphones, headphones are much preferred to speakers for cueing overdubs.
In many situations, it may be sufficient to plug all headphones directly into an HA-6A or other headphone amp. However, in a larger studio, or when each musician must have easy access to his or her headphone volume control, it is more practical to use several HR-2 Remote Stations at strategic locations around the room. In this case, the HA-6A (or the stereo power amplifier substituting for it) would most likely be installed in the control room.
The HR-2 Remote Stations connect in "daisy chain" fashion to the SPEAKER B-SATELLITE/REMOTE output on the rear panel of the HA-6A. This output is a male 3-pin XLR connector, so that ordinary microphone cables can be used. The HA-6A connects to the first HR-2 box; another mic cable connects the first HR-2 to the second HR-2; a third mic cable connects the second HR-2 to the third HR-2; and so on. If low impedance headphones are used, up to 12 HR-2s may be chained together. If medium or high impedance headphones are used, 25 or more Remote Stations may be chained.
The HR-2 Remote Stations are compact boxes which easily attach with a thumbscrew to any microphone stand. Each HR-2 has 2 stereo volume controls and 2 headphone jacks, to accommodate 2 listeners. There are also 2 XLR connectors, one male and one female, for use in daisy-chaining units together. If desired, the clip on an HR-2 box may be hung on a belt if no microphone stand is convenient. Or, the clip itself may be popped off the box for tabletop use.
For most products, Furman has a very generous Limited
Warranty term of three years for defects in materials or workmanship on
registered units. For units that have not been registered, the Limited Warranty
period is twelve months. Our warranty covers parts and labor, with the term
measured from the date of purchase of the new unit by the original owner. The
warranty is not transferable. Extended Warranties are no longer sold, but those
that have been purchased in the past will be honored as long as the contracted
term is in effect.This warranty policy applies only to standard Furman
products. RackRider products and Furman "Performance Series" products have a 90
day warranty term.
Furman Website
3900 Fiscal Ct, Suite 200 West Palm Beach, Florida 33404 USA
Telephone: 1-877-778-7845
Toll Free or 561-842-7451
Fax:
561-840-9032Contact Us! Hours: Mon-Fri 930 am - 630 pm ET/
Sat 11 am - 4 pm ET/Sun: Closed
Zoom / More pics 
Print this Page 
Details 
WhyFurman 
More Pics 
Warranty 
